Manufacturer: YJ Link
Model: Combination Mag Loader – Destacker
Reference No.: 307L
Specifications:
Click the images below for additional views.
FAST response, within an hour or less.
Manufacturer: PVA TePla
Model: IoN-140
S/N: IoN-2030
Reference No.: 306L
Specifications:
Click the images below for additional views.
FAST response, within an hour or less.
Manufacturer: Vi Technology
Model: 5K SPECTRO 2D AOI
D.O.M.: 2015
S/N: 1506A1168
Reference No.: 305L
Specifications:
5K-Spectro Automated Optical Inspection System
Click the images below for additional views.
FAST response, within an hour or less.
Manufacturer: TestEquity
Model: 1007H
Reference No.: 281LC
Description: TestEquity Model 1007H Temperature/Humidity Chamber
Standard Range: 10% to 95%
(Limited by a 6°C dewpoint and maximum dry bulb of +85°C)
With optional GN2 Purge or Dry Air Purge: 5% to 95%
(Dry bulb range of +10°C to +85°C)
NOTE: Ability to reach RH extremes may be limited by the humidity sensor accuracy. Low Dew Point conditions can only be achieved when starting with a clean, dry chamber.
| Cool Down Transition Time* (uncontrolled humidity mode) | ||||||
| Start Temp | End Temp | |||||
| +23°C | 0°C | -40°C | -55°C | -65°C | -73°C | |
| +23°C | —– | 4 min | 18 min | 25 min | 33 min | Ultimate |
| +50°C | 5 min | 11 min | 27 min | 36 min | 45 min | Ultimate |
| +85°C | 13 min | 20 min | 37 min | 47 min | 55 min | Ultimate |
| +150°C | 32 min | 39 min | 58 min | 65 min | 76 min | Ultimate |
| Heat Up Transition Time* (uncontrolled humidity mode) | ||||||
| Start Temp | End Temp | |||||
| +23°C | +50°C | +85°C | +125°C | +150°C | +175°C | |
| +23°C | —– | 1.5 min | 7 min | 14 min | 20 min | 25 min |
| 0°C | 1.5 min | 3.5 min | 13 min | 20 min | 23 min | 31 min |
| -40°C | 6 min | 11 min | 17 min | 24 min | 30 min | 35 min |
| -55°C | 8 min | 13 min | 19 min | 26 min | 32 min | 37 min |
| -65°C | 10 min | 14 min | 21 min | 28 min | 34 min | 39 min |
Rate Of Change
To calculate rate of change for a particular condition, take the difference between the Start Temp and End Temp and divide by the Transition Time.
Cool Down Example: From +50°C to -40°C = 90°C / 27 min = 3.33°C/min.
Heat Up Example: From -40°C to +50°C = 90°C / 11 min = 8.18°C/min.
*Note: Transition times are measured after a 2 hour soak at the respective start temperature with an empty chamber, as indicated on the temperature controller, 23°C ambient. Measured with setpoint beyond the start and end temperatures. Does not include the effect of proportional band when approaching setpoint. Performance is reduced by 17% with 50 Hz input power.
| Live Load Capacity (uncontrolled humidity mode) | |||||
| +23°C | 0°C | -40°C | -55°C | -65°C | |
| 1,000 Watts | 800 Watts | 500 Watts | 400 Watts | 300 Watts | |
| Refrigeration and Heating System | ||
| High Stage Refrigerant | R-404A (Dupont HP-62) | |
| Low Stage Refrigerant | R-508B (Dupont SUVA-95) | |
| Compressors | 1.5 HP x 1.5 HP Tecumseh hermetic compressors in a cascade configuration. | |
| Condenser | Air Cooled | |
| Heat of Rejection | 14,800 BTUH (maximum rated chamber load at maximum cooling rate from high temperature soak) | |
| Air Heater Power | 2,000 Watts | |
| Humidifier Heater Power | 1,500 Watts (rating at 240V) | |
| Air Flow | 450 cfm | |
| Instrumentation | ||
| Temperature Controller | Watlow F4T Touch Screen Controller with RS-232, Ethernet interface, 4.3″ color graphic touch screen. OR… Watlow F4 Controller with RS-232 interface, LED readout of temperature, LCD display of other parameters. |
|
| Limit Controller | Independent high and low temperature limits. Triggers an audible alarm and shuts down the chamber. Relay contacts provide a safety power interlock for test sample. | |
| Chart Recorder | (Optional) Honeywell DR4300 Series. One pen, 10″ circular chart. Mounts in lower front door. |  |
| Input Power Requirements | |||
| Phase | Current Draw | Minimum Service | |
| 230 V ±10%, 60 Hz | 1 PH | 25 A | 30 A |
| 3 PH | 19 A | 25 A | |
| 208 V -5/+10%, 60 Hz | 1 PH | 28 A | 35 A |
| 3 PH | 21 A | 30 A | |
Input may be configured for single or three phase in the field by changing jumpers. Three phase load is semi-balanced. Call for other voltages or 50 Hz operation. Performance is reduced by 17% at 50 Hz.
Customer power source must be hard-wired to the chamber by a qualified electrician. Power cord and plug is not included.
| Humidity Water Requirements | |
| Supply and Drain | Must be provided with a water line and floor drain. Negligible consumption. |
| Water Recirculation System (optional) | Provides a reliable supply of filtered water for the humidity system. Perfect for installations where a water line and drain are not available. |
| Physical Characteristics and Safety | |
| Inside Dimensions | 24″ W x 21″ H x 24″ D (7 cubic feet) 609 mm W x 533 mm H x 609 mm D (198 liters) |
| Outside Dimensions | 33″ W x 68.75″ H x 54″ D (nominal) 838 mm W x 1746 mm H x 1372 mm D |
| Door latch adds 3″ to width on right side (may be removed to permit move-in through a 36″ doorway). Circulator motor and housing adds 6″ to height. | |
| Minimum Installed Clearance | 18″ from the left and right side 24″ from the rear |
| Window Viewing Area | 13.375″ W x 9″ H |
| Access Ports | 4″ Port on left and right side (two total) Supplied with foam plugs |
| Weight | Chamber Weight: 890 pounds Shipping Weight: 1,058 pounds |
| Sound Level | 62 dBA in cooling mode (A-weighted, measured 36″ from the front or side surface, 63″ from the floor, in a free-standing environment) |
NOTE: Performance is typical and based on operation at 23°C (73°F) ambient and nominal input voltage. Designed for use in a normal conditioned laboratory. Operation at higher ambient temperatures may result in decreased cooling performance. Additional ports and shelves will also affect performance. Operation above 30°C (85°F) or below 16°C (60°F) ambient is not recommended.
Contact SMT Sales Group for additional details.
FAST response, within an hour or less.
Manufacturer: Simplimatic
Model: 3101L
DOM: 2011
Serial No: M261670
Reference No.: 279LC
Description: Simplimatic 3101L Wave Solder Pallet Return System.
Contact SMT Sales Group for additional details.
FAST response, within an hour or less.
Manufacturer: Simplimatic
Model: Entrance Conveyor
Reference No.: 277LC
Description: Simplimatic Wave Entrance Conveyor
This conveyor is a drop and tilt wave entrance conveyor.
Contact SMT Sales Group for additional details.
FAST response, within an hour or less.
Manufacturer: Simplimatic
Model: 3012
Reference No.: 276LC
Serial No: M250240
Description: Simplimatic Wave Exit Conveyor (2 pieces).
This is a very high-wave exit conveyor (2 pieces). The first part is actually the wave exit with Collings fans. From there it goes into an elevator that lowers the boards back down to line-height.
Contact SMT Sales Group for additional details.
FAST response, within an hour or less.
Manufacturer: CTI
Model: 90 Degree Turn Conveyor
Reference No.: 274LC
Description: CTI 90 Degree Turn Conveyor
Contact SMT Sales Group for additional details.
FAST response, within an hour or less.
Manufacturer: Simplimatic
Model: 1 Meter Workstation Conveyor
Reference No.: 272LC
Description: This is a 1 Meter Simplimatic workstation conveyors (2 Segment) with inspection
FAST response, within an hour or less.
Manufacturer: YJ Link
Models: AUD-CE & ALD-CE
Year: 2010
Serial No: 1806-0255-10-CC-1288 (AUD-CE)
Serial No: 1806-0255-01-CC-1274 (ALD-CE)
Reference No.: 271LC
Description: 2018 YJ Link ALD-CE & AUD-CE magazine loader, magazine unloader, and 12 magazines.
Details:
FAST response, within an hour or less.
